Chapter 6. Manage / Configure the Switch
49
interface Enters privileged interface configuration
ip-filter Set ipaddress filter
lacp Configures LACP status
map Maps priority
maximum-packet-length Configures the maximum packet length of the port
mdi-mdix Configures the MDI or MDIX of the port
mvr Multicast VLAN Registration
no Negates a command or sets its defaults
port Configures the characteristics of the port
port-vlan Configures Port-Based VLAN
power-saving Decrease energy consumption
qos Configuration of QoS
rate-limit Configures rate-limits
shutdown Shuts down the selected interface
spanning-tree Specifies spanning tree configuration
speed Configures speed operation
switchport Configures switching mode characteristics
----------------------------------------------------------------------------------------------------------
1 exit command
This command is used to leave current operation mode. Go back to last mode.
2 help command
This command is used to show all the available commands in this mode.
3 history command
This command is used to show the history of entering commands.
4 logout command
This command is used to logout from console interface.
5 quit command
This command is used to quit from console interface. It has the same function as logout.
To Next Page
Loading...
Need help?
General
