Chapter 6. Manage / Configure the Switch
62
Entering “interface vlan 100”, and its prompt will become ...
(config)# interface vlan 100
(config-if)#
Enter “?” at the prompt, the sub-command list will be shown.
-------------------------------------------------------------------------------
(config-if)# ?
exit Exit from current mode
help Show available commands
history Show a list of previously run commands
logout Disconnect
quit Quit commands
interface Enters privileged interface configuration
ip Internet protocol
no Negates a command or sets its defaults
-------------------------------------------------------------------------------
1. exit command
This command is used to leave current operation mode. Go back to last mode.
2. help command
This command is used to show all the available commands in this mode.
3. history command
This command is used to show the history of entering commands.
4. logout command
This command is used to logout from console interface.
To Next Page
Loading...
Need help?
General
