Chapter 6. Manage / Configure the Switch
73
show interface status command will show port status of all ports (one after another).
show interface status ethernet 1/x command will show port status of Port x. (“x” is the port number).
For example,
# show interface status ethernet 1/5
Basic information:
Port type: 1000TX
Mac address: 00:11:22:64:99:6F
Configuration:
Name: Port 5
Port admin: Enable
Speed-duplex: Auto_on
Capabilities: 10half,10full,100half,100full,1000full
Broadcast storm: Disable
Flooded unicast storm: Disable
Multicast storm: Disable
Flow control: Disable
Power saving: Disable
LACP: Disable
Max MAC count: 0
Maximum Packet Length: 9600
IPaddress Filter: 1
Current status:
Link status: Up
Operation speed-duplex: 100Half
MDI/MDI-X: Auto
show interface switchport command will show function configuration of all ports (one after another).
show interface switchport ethernet 1/x command will show function configuration of Port x. (“x” is the port
number).
For example,
# show interface switchport ethernet 1/5
Information of Eth 1/5
To Next Page
Loading...
Need help?
General
