CUMMINS ALLISON JetScan iFX i100 - Step-by-step cleaning instructions

© 2013 Cummins-Allison Corp.
87
1.
Turn power
OFF
(rocker panel to
0
).
2.
Grasp release sleeve on power-
cord connector. Disconnect
power cord from machine.
3.
Lift adjustable hopper to the upright position.
4.
Use a dry microfiber towel to clean the black start sensor at the
top, middle of the feeder plate (shown at left).
5.
Flat, center rubber-drive tire
Use a Simple Green Safety Towel to clean all rubber sections
of the large, black feed rollers. Rotate the rollers.
Next, use a Simple Green Safety Towel to clean the flat, center
rubber-drive tire (shown at left).
6.
Lift display panel to the upright position.
7.
Push release levers down to disengage the upper-transport plate.
8.
Lift upper-transport plate to the locked position.
Release
sleeve