© 2013 Cummins-Allison Corp.
Align and justify documents
to the wide horizontal edge.
8. Prepare documents for processing, as described below:
• Ensure documents are unfolded and neatly stacked.
• Align and justify documents to the wide horizontal edge.
• Facing and orientation are not required.
• When processing checks, raise the adjustable hopper guides.
• Place documents in the hopper with the horizontal and justified edge toward the feed opening.
This reduces the risk of feed errors and no calls.
9. The machine processes the documents.
If the machine stops due to an error, read the instructions on the main screen. For more
information, see Stopping Conditions and Recovery Steps.
10. The machine stops automatically after the last document in the hopper has been run. The batch is
ended when documents are removed from the pocket. If the ADD key is ON, press END to end the
batch, restart the count, and begin the next batch.
The ADD Key and Sub-Batches
A sub-batch is a deposit processed from one or several sources and treated as sub-groups within
a batch. This memory level tracks documents within a sub-batch.
To accumulate sub-batches, ensure SBAT ENABLE is ON in SETUP and ADD is selected on
the main screen.
To end the batch when processing is complete, remove documents from the pocket and press
END twice: once to end the sub-batch and once to end the batch.
An example of a COUNT mode main screen is shown below. The ADD key is ON, and SBAT
ENABLE is ON in SETUP.
To Next Page
Loading...
Need help?
General
