2
GenesisPlus Operator Manual
D1151, R
EV C, 10/16
WARNING
Any laser device can generate highly concentrated light, which may
cause injury if improperly used. To protect patients and operating
personnel, this entire operator manual, including the Safety and
Regulatory section, should be carefully read and comprehended
before operation.
System Preparation
The GenesisPlus system is shipped directly from the factory to your site. Your local Cutera
representative will initially uncrate, inspect, set up and install the system to ensure that it is
working properly before use. In addition, Cutera provides in-service and training to ensure that
your staff is experienced with appropriate performance and safety considerations. Thereafter,
you or the staff at your facility will be performing the daily maintenance routines associated
with the system, as well as performing basic system safety checks. These procedures are
detailed later in this chapter and in the Maintenance section of this manual.
Most staff personnel prefer to inspect and perform a functional system check prior to sched-
uled cases. Doing so will ensure adequate time to troubleshoot problems or to contact your ser-
vice representative with the least amount of disruption to patients and schedules.
To Next Page
Loading...
