D-Link DGS-1100-16/ME

DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide
DGS-1100-24P/ME:admin#
config igmp_snooping multicast_vlan_group
Purpose To specify that IGMP snooping is to be configured for multicast vlan
groups on the Switch.
Syntax
config igmp_snooping multicast_vlan_group <vlan_name 8>
[add | delete] ipv4_range <mcast_address_range>
Description
The config igmp_snooping multicast_vlan_group command
specifies an IGMP snooping multicast VLAN group on the Switch.
Parameters
<vlan_name 8> − The name of the VLAN for which IGMP snooping
is to be configured. Up to 8 characters can be used.
[add | delete] − Specify whether to add or delete address range
defined in the following parameter <mcast_address_range>.
ipv4_range <mcast_address_range> − Specify the address to be
configured with the IGMP snooping multicast VLAN group.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure the igmp snooping multicast VLAN:
DGS-1100-24P/ME:admin#config igmp_snooping multicast_vlan_group
test add ipv4_range 227.0.0.1-228.0.0.1
Command : config igmp_snooping multicast_vlan_group test add
ipv4_range 227.0.0.1-228.0.0.1
Success.
DGS-1100-24P/ME:admin#
enable igmp_snooping multicast_vlan
Purpose To enable IGMP snooping multicast VLAN on the Switch.
Syntax
enable igmp_snooping multicast_vlan
Description
The enable igmp_snooping multicast_vlan
command enables
IGMP snooping multicast VLAN on the Switch.
IGMP snooping and IGMP snooping multicast VLAN behave
differently in the same packet. If both are enabled at the same time,
only IGMP snooping works.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage:
To enable IGMP snooping multicast VLAN on the Switch:
DGS-1100-24P/ME:admin#enable igmp_snooping
multicast_vlan
Command : enable igmp_snooping multicast_vlan
97