D-Link DGS-1100-16/ME

DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide
16
VLAN COMMANDS
The VLAN commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameter
create vlan [name <vlan_name 8> tag<vlanid 2-4094> | vlanid <vidlist 2-4094>]
delete vlan [name <vlan_name 8> | vlanid <vidlist 2-4094>]
config vlan
[name <vlan_name 8> [add [tagged | untagged] | delete ] <portlist> | vlanid
<vidlist 1-4094>] [[add [tagged | untagged] | delete ] <portlist> | name
<vlan_name 8>]]
show vlan {name <vlan_name 8> | vlanid <vidlist 1-4094> | ports <portlist>}
enable asymmetric_
vlan
disable
asymmetric_vlan
show asymmetric_vlan
enable
management_vlan
disable
management_vlan
config
management_vlan
vlanid <vlanid 1-4094>
show
management_vlan
config port_vlan <portlist> pvid <vlanid 1-4094>
show port_vlan {port <portlist>}
enable pvid
auto_assign
disable pvid
auto_assign
show pvid auto_assign
Each command is listed in detail, as follows:
create vlan
Purpose To create a VLAN on the Switch.
Syntax
create vlan [name <vlan_name 8> tag<vlanid 2-4094> | vlanid
<vidlist 2-4094>]
78