Purpose To display the configuration of an IP interface on the Switch.
Syntax
show ipif
Description
The show ipif command displays the configuration of an IP interface
on the Switch.
Parameters None.
Restrictions None.
Example usage:
To display IP interface settings:
DGS-1100-24P/ME:admin#show ipif
Command: show ipif
IPv4 Type : DHCP
IPv4 Address : 10.90.90.90
IPv4 mask : 255.0.0.0
Gateway : 0.0.0.0
DHCP retry time : 7
IPv6 state : disabled
IPv6 address : fe80:0:0:0:2e0:95ff:fe66:77d0
DGS-1100-24P/ME:admin#
88
To Next Page
Loading...
