D-Link DGS-1100-16/ME

DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide
26
ZONE DEFENSE COMMANDS
The Zone Defense commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameter
enable zone_defense
disable zone_defense
show zone_defense
Each command is listed in detail, as follows:
enable zone_defense
Purpose To enable zone defense support of the switch.
Syntax
enable zone_defense
Description
The enable zone_defense command enables zone defense support
of the switch.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage:
To enable zone defense support
DGS-1100-24P/ME:admin#enable zone_defense
Command : enable zone_defense
Success.
DGS-1100-24P/ME:admin#
disable zone_defense
Purpose To disable zone defense support of the switch.
Syntax
disable zone_defense
Description
The disable zone_defense command disables zone defense
support of the switch.
Parameters None.
Restrictions Only administrator-level users can issue this command.
135