D-Link DGS-1100-16/ME

DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide
Command Parameter
static_group
Each command is listed in detail, as follows:
enable mld_snooping
Purpose To enable MLD snooping on the Switch.
Syntax
enable mld snooping
Description
The enable mld snooping command enables MLD snooping on the
Switch.
If IGMP snooping is also enabled, this operation may possibly fail
due to the total number of group entrys exceeding the limitation of
group table.
Parameters
None.
Restrictions Only administrator-level users can issue this command.
Example usage:
To enable the MLD snooping:
DGS-1100-24P/ME:admin#enable mld_snooping
Command : enable mld_snooping
Success.
DGS-1100-24P/ME:admin#
disable mld_snooping
Purpose To disable MLD snooping on the Switch.
Syntax
disable mld snooping
Description
The disable mld snooping command disables MLD snooping on
the Switch. Disabling MLD snooping allows all MLD and IP multicast
traffic to flood within a given IP interface.
Parameters
None.
Restrictions Only administrator-level users can issue this command.
Example usage:
To disable the MLD snooping:
DGS-1100-24P/ME:admin#disable mld_snooping
Command : disable mld_snooping
Success.
DGS-1100-24P/ME:admin#
103