D-Link DGS-1100-16/ME

DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide
24
SAFEGUARD COMMANDS
The Safeguard commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameter
config
safeguard_engine
state [enable | disable]
show
safeguard_engine
Each command is listed in detail, as follows:
config safeguard_engine
Purpose To define the safeguard engine on the switch.
Syntax
config safeguard_engine state [enable | disable]
Description To define the safeguard_engine on the switch.
Parameters
state [enable | disable] – enable and disable Safeguard engine on
the Switch.
Restrictions Only administrator-level users can issue this command.
Example usage:
To enable the safeguard engine on the switch:
DGS-1100-24P/ME:admin#config safeguard_engine state enable
Command: config safeguard_engine state enable
Success
DGS-1100-24P/ME:admin#
show safeguard_engine
Purpose To show the safeguard engine status on the switch.
Syntax
show safeguard_engine
Description To show the safeguard engine on the switch.
Parameters None.
Restrictions None.
128