D-Link DGS-1100-16/ME

DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide
21
POWER SAVING COMMANDS
The Power Saving commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameter
config power_saving global
[[link_detection_scheduled | port_shutdown_scheduled | hiberantion_scheduled |
dim-led_scheduled | administrative_dim-led ] [enable | disable] | time_profile
[dim-led | hibernation] [add <range_name 8> | delete]]
config power_saving port [port_list <portlist> | all] [time_range <range_name 8> | clear_time_range]
show power_saving
{global | port}
Each command is listed in detail, as follows:
config power_saving global
Purpose To configure the power saving mode on the switch.
Syntax
config power_saving global [[link_detection_scheduled |
port_shutdown_scheduled | hibernation_scheduled | dim-
led_scheduled | administrative_dim-led ] [enable | disable] |
time_profile type [dim-led | hibernation] time_range [add
<range_name 20> | delete] ]
Description
The config power_saving global command is used to configure
the power saving mode on the switch.
Parameters
link_detection_scheduled – Configure the link detection state to
enable or disable. The default value is disabled.
port_shutdown_scheduled – Configure the port shutdown state to
enable or disable. The default value is disabled.
hiberanation_scheduled – Configure the hibernation state to enable
or disable. The default value is disabled.
dim-led_scheduled – Configure dim led state to be enabled or
disabled.
administrative_dim-led – Configure administrative dim-led state to be
enabled or disabled.
[enable | disable] – Enable or disable the power saving feature.
dim-led – The dim-led type of time profile.
hibernation – The hibernation type of time profile.
add <range_name 8> - The time profile name to add for power
saving.
delete – remove the time profile for power saving.
Restrictions Only administrator-level users can issue this command.
120