D-Link DGS-1100-16/ME

DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure the speed of ports 1-3 to be 100 Mbps, full duplex:
DGS-1100-24P/ME:admin#config ports 1-3 speed 100_full
Command : config ports 1-3 speed 100_full
Success.
DGS-1100-24P/ME:admin#
show ports
Purpose To display the current configuration of a range of ports.
Syntax
show ports <portlist>
Description
The show ports command displays the current configuration
of a
port or range of ports.
Parameters
<portlist> − A port or range of ports whose settings are to be
displayed..
Restrictions None.
Example usage:
To display the configuration of port 5 on the Switch:
DGS-1100-24P/ME:admin#show ports 5
Command : show ports 5
Port State/ Settings Connection Address
MDI Speed/Duplex/FlowCtrl Link Status Learning
------- -------- ------------------------------------ ------------------- ---------
5 Enabled Auto/Auto/Disabled Link Up Enabled
Auto
Description:
DGS-1100-24P/ME:admin#
33