D-Link DGS-1100-16/ME

DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide
reset
Purpose To reset the Switch to the factory default settings.
Syntax
reset [config | system | default] {force_agree}
Description
The reset system command restores the Switch’s configuration to
the factory default settings. Rebooting will clear all entries in the
Forwarding Data Base.
Parameters
config − Specify this keyword and all parameters are reset to default
settings. However, the device will neither save nor reboot.
system − Specify this keyword and all parameters are reset to
default settings. Then the switch will do a factory reset, save, and
reboot.
default − Specify this keyword and all parameters are reset to
default settings except the IP address.
force_agree - When force_agree is specified, the reset command
will be executed immediately without further confirmation.
Restrictions Only administrator-level users can issue this command.
Example usage:
To restore all of the Switch’s parameters to their default values:
DGS-1100-24P/ME:admin#reset system
Command : reset system
Are you sure you to proceed with system reset, save and reboot?(y/n) y
Please wait, the switch is rebooting...
login
Purpose To log in a user from the Switch.
Syntax
login
Description
The login command terminates the current user’s session on the
Switch.
Parameters None.
Restrictions None.
Example usage:
To terminate the current user’s Telnet session:
DGS-1100-24P/ME:admin#login
Command : login
Success.
UserName:
25