D-Link DGS-1100-16/ME

DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide
Example usage:
To configure STP ports settings
DGS-1100-24P/ME:admin#config stp ports 5-10 edge true
Command : config stp ports 5-10 edge true
Success.
DGS-1100-24P/ME:admin#
show stp ports
Purpose To display the edge state of each port.
Syntax
show stp ports {portlist <portlist>}
Description
The show stp ports command displays the edge mode of each
port.
Parameters
portlist <portlist> – Specifies the port list to be display.
Restrictions None.
Example usage:
To display STP ports status.
DGS-1100-24P/ME:admin#show stp ports portlist 5-8
Command : show stp ports portlist 5-8
Port Edge State
------ -------- ----------
eth5 True Link down
eth6 True Link down
eth7 True Link down
eth8 True Link down
DGS-1100-24P/ME:admin#
config stp trap
Purpose To set the STP trap status.
Syntax
config stp trap { new_root [ enable | disable ] | topo_change
[ enable | disable ] } (1)
Description
The config stp trap command sets the STP trap status.
Parameters
new_root [enable | disable] – Enable/Disable the new root traps
support.
tppo_change [enable | disable] – Enable/Disable the topology
change traps support.
Restrictions Only administrator-level users can issue this command.
131