D-Link DGS-1210-08P - Page 151

6 Command Line Interface D-Link Smart Managed Switch User Manual
144
config configuration
Purpose To specify which configuration file to be configured.
Syntax config configuration config_id <integer (1-2)> {delete |
boot_up}
Description
The config configuration command configures the configuration
image to be deleted or boot up on the Switch.
Parameters config_id <integer (1-2)> −
Specifies the image 1 or 2 to be
configured.
{delete | boot_up} –
Specifies the configuration image to be
deleted or boot up.
Restrictions None.
Example usage:
To configure the configuration image id 1 to be used when boot up on the Switch:
DGS-1210-52MP> config configuration config_id 1 boot_up
Success.
DGS-1210-52MP>
config firmware
Purpose To configure which firmware image to be boot up.
Syntax config firmware image id <integer (1-2)> boot_up
Description The config firmware image id
command configures the
firmware image to be boot up on the Switch.
Parameters <integer (1-2)> − Specifies the image 1 or 2 to be configured.
boot_up – Specifies the specified image to be boot up.
Restrictions None.
Example usage:
To configure the firmware image id 1 to be used when boot up on the Switch:
DGS-1210-52MP> config firmware image_id 1 boot_up
DGS-1210-52MP>
upload
Purpose To upload the firmware file or a Switch configuration file to a
TFTP server.
Syntax upload {firmware_toTFTP {<ipaddr>| <ipv6addr>}
<path_filename (64)> image_id <integer 1-2> | cfg_toTFTP
{<ipaddr>| <ipv6addr>} <path_filename (64)>}
config_id<integer (1-2)>}
Description The upload command uploads the Switch’s current settings to a
TFTP server.