D-Link DGS-1210-08P - Page 150

6 Command Line Interface D-Link Smart Managed Switch User Manual
1
1
4
4
3
3
config ipif <ipif_name> { ipv6 ipv6address <ipv6networkaddr> | dhcpv6_client {
enable | disable}}
debug info
disable ddpClient
disable nmsManaged
download profile_fromTFTP {<ip_addr>| <ipv6_addr>} <string>
download {firmware_fromTFTP {<ipaddr>| <ipv6addr>} <path_filename (64)> | cfg_
fromTFTP {<ipaddr>| <ipv6addr>} <path_filename (64)> config_id <integer (1-2)>}
enable ddpClient
enable nmsManaged
logout
ping <ip_addr>
ping6 <ipv6addr>
reboot
reset config
save [config config_id <integer (1-2)> ]
show boot_file
show ddpClient
show firmware information
show ipif [<ipif_name>]
show nmsManaged
show route { ipv4 | ipv6 }
show switch
upload {firmware_toTFTP {<ipaddr>| <ipv6addr>} <path_filename (64)> image_id <
integer 1-2> | cfg_toTFTP {<ipaddr>| <ipv6addr>} <path_filename (64)> config_id
<integer (1-2)>}
DGS-1210-24P>
config account
Purpose To configure the password for administrator account.
Syntax config account admin password <passwd>
Description The config account admin password command is used to
configure the password for admin account.
Parameters <passwd> − Accepts string up to 20 characters.
Restrictions Administrator.
Example usage:
To configure the password for account “admin”:
DGS-1210-10P> config account admin password dlink1234
DGS-1210-10P>