D-Link DGS-1210-08P - Page 153

6 Command Line Interface D-Link Smart Managed Switch User Manual
146
Success.
DGS-1210-52MP>
config ipif System
Purpose To configure the System IPv6 interface.
Syntax config ipif <ipif_name> { ipv6 ipv6address
<ipv6networkaddr> | dhcpv6_client [enable | disable] }
Description The config ipif system command configures the System IPv6
interface on the Switch.
Parameters <ipif_name> − Specifies the ipif name to be configured.
ipv6 ipv6address <ipv6networkaddr> −
Use this parameter to
statically assign an IPv6address to this interface. This address
should define a host address and a
network prefix length.
Multiple IPv6 addresses can be configured for a
single IP
interface. Ex: 3ffe:501:ffff:100::1/64. The /64 represents the prefix
length of the IPv6 addresses.
dhcpv6_client [enable | disable] − Specifies the DHCPv6 client to
be disabled or enabled.
Restrictions None.
Example usage:
To configure the IPv6 interface System:
DGS-1210-52MP> config ipif System ipv6 ipv6address 3ffe:501:ffff:100::1/64
Success.
DGS-1210-52MP>
debug info
Purpose To display the ARP table and MAC FDB information of the
Switch.
Syntax debug info
Description The debug info command
displays the ARP table and MAC
FDB of the Switch.
Parameters None.
Restrictions None.
Example usage:
To display the ARP table and MAC FDB information of the Switch:
DGS-1210-52MP> debug info
% sgementation fault log file :
File doesn't exist !!!