D-Link DGS-1210-08P - Page 154

6 Command Line Interface D-Link Smart Managed Switch User Manual
1
1
4
4
7
7
% ARP table :
Address Hardware Address Type Interface Mapping
------- ---------------------------- --------- ------------- --------------
10.0.0.0 ff-ff-ff-ff-ff-ff ARPA vlan1 Static
10.90.90.90 4a-6f-6e-01-01-01 ARPA vlan1 Static
10.90.90.96 3c-97-0e-e5-76-4d ARPA vlan1 Dynamic
10.255.255.255 ff-ff-ff-ff-ff-ff ARPA vlan1 Static
% MAC table :
Vlan Mac Address Type Ports
----- ------------------------ ---------- ------------
1 3c:97:0e:e5:76:4d Learnt Gi0/5
Total Mac Addresses displayed: 1
% POE MCU VERSION :
PoeVersion : 24 (0x18)
PoeExtVersion : 33 (0x21)
DGS-1210-52MP>
disable ddpclient
Purpose Turn off D-Link Discover Protocol.
Syntax disable ddpclient
Description The disable ddpclient command is used to turn off D-Link
Discover Protocol feature.
Parameters None.
Restrictions Administrator only.
Example usage:
To turn off D-Link Discover Protocol:
DGS-1210-10P> disable ddpClient
DGS-1210-10P>
disable nmsManaged
Purpose Turn off D-Link Nuclias Connect feature.
Syntax disable nmsManaged
Description The disable nmsManaged command is used to turn off D-Link