6 Command Line Interface D-Link Smart Managed Switch User Manual
150
Purpose Turn on D-Link Nuclias Connect feature.
Syntax enable nmsManaged
Description The enable nmsManaged command is used to turn on D-Link
Nuclias Connect feature.
Parameters None.
Restrictions Administrator only.
Example usage:
To turn off D-Link Nuclias Connect Feature:
DGS-1210-10P> enable nmsManaged
Device will reboot and connect to Nuclias Connect automatically.
Current running config will be reset to default automatically.
Do you want to continue?[Y/n]
DGS-1210-10P>
logout
Purpose To log out a user from the Switch’s console.
Syntax logout
Description The logout command terminates the current user’s session on
the Switch’s console.
Parameters None.
Restrictions None.
Example usage:
To terminate the current user’s console session:
DGS-1210-52MP> logout
NOTE: Save your configuration changes before
logging out.
Purpose To test the connectivity between network devices.
Syntax ping <ip_addr>
Description The ping command checks if another IP address is reachable on
the network. You can ping the IP address connected to through
the managed VLAN (VLAN 1 by default), as long as there is a
physical path between the switch and the target IP equipment. By
default, Switch sends five pings to the target IP.
Parameters <ip_addr> − The IPv4 address of the host.
Restrictions None.
Example usage:
To Next Page
Loading...
