D-Link DGS-1210-08P - Page 156

6 Command Line Interface D-Link Smart Managed Switch User Manual
1
1
4
4
9
9
Note: Switch will reboot after restore and
all current configurations will be lost.
download profile_fromTFTP
Purpose To download D-Link Nuclias Connect profile from TFTP server.
Syntax download profile_fromTFTP {<ip_addr>| <ipv6_addr>}
<string>
Description The download profile_fromTFTP command is used to download
the particular D-Link Nuclias Connect profile from TFTP server.
Parameters <ipaddr> − The IPv4 address of the TFTP server.
<ipv6addr> − The IPv6 address of the TFTP server.
<string> − The filename on the TFTP server. You need to specify
the DOS path if the file is not at the root directory of the TFTP
server.
Restrictions Administrator only.
Example usage:
To download D-Link Nuclias profile “dlink_test_profile” from TFTP server:
DGS-1210-10P> download profile_fromTFTP 192.168.11.141 dlink_test_profile.dat
Device will reboot and connect to Nuclias Connect automatically after network file is
uploaded.
Current running config will be reset to default automatically.
Do you want to continue?[Y/n]
DGS-1210-10P>
NOTE: Save your configuration changes before
logging out.
enable ddpclient
Purpose Turn on D-Link Discover Protocol.
Syntax enable ddpclient
Description The enable ddpclient command is used to turn on D-Link
Discover Protocol feature.
Parameters None.
Restrictions Administrator only.
Example usage:
To turn on D-Link Discover Protocol:
DGS-1210-10P> enable ddpClient
DGS-1210-10P>