6 Command Line Interface D-Link Smart Managed Switch User Manual
152
Example usage:
To restart the Switch:
DGS-1210-52MP> reboot
% Device will reboot, please wait a few minutes to re-login.
DGS-1210-52MP>
Purpose To reset the Switch to the factory default settings.
Syntax reset config
Description All configurations will be reset to the default settings.
Parameters None.
Restrictions None.
Example usage:
To restore all of the Switch’s parameters to their default values:
DGS-1210-52MP> reset config
% Device will reboot after reset configuration successfully.
DGS-1210-52MP>
Purpose To save changes in the Switch’s configuration to non-volatile
RAM.
Syntax save [config config_id <integer (1-2)>]
Description The save command
saves the configuration changes to the
memory.
Parameters None.
Restrictions None.
Example usage:
To save the Switch’s current configuration to non-volatile RAM:
DGS-1210-52MP> save config config_id 2
Building configuration ...
[OK]
DGS-1210-52MP>
show boot_file
Purpose To display the information of the boot file on the Switch.
Syntax show boot_file
Description The show boot_file command displays the current information of
To Next Page
Loading...
