D-Link DGS-1210-08P - Page 160

6 Command Line Interface D-Link Smart Managed Switch User Manual
1
1
5
5
3
3
boot file on the switch.
Parameters None.
Restrictions None.
Example usage:
To the information of the boot file on the Switch:
DGS-1210-52MP> show boot_file
Bootup Firmware : image_1
Bootup Configuration : config_1
DGS-1210-52MP>
show ddpclient
Purpose To display the current status of D-Link Discover Protocol.
Syntax show ddpclient
Description The show ddpclient command displays the current status of D-
Link Discover Protocol.
Parameters None.
Restrictions None.
Example usage:
To display the current status of D-Link Discover Protocol:
DGS-1210-10P> show ddpClient
Enable
DGS-1210-10P>
show firmware information
Purpose To display the firmware information on the Switch.
Syntax show firmware information
Description The show firmware information command displays the current
firmware information on the switch.
Parameters None.
Restrictions None.
Example usage:
To the firmware information on the Switch:
DGS-1210-08P> show firmware information
Version : 7.30.003
Size : 12288000 Bytes
Updated Time : 01/01/1970 00:00:00
From : 10.90.90.90