D-Link DGS-1210-08P - Page 163

6 Command Line Interface D-Link Smart Managed Switch User Manual
156
DGS-1210-08P> show switch
System name :
System Contact :
System Location :
System up time : 7 days, 0 hrs, 32 min, 47 secs
System Time : 08/01/2020 00:32:18
System hardware version : G1
System firmware version : 7.30.003
System boot version : 1.01.001
System serial number : QBDES12105200
MAC Address : 00-11-12-29-08-01
DGS-1210-08P>
upload
Purpose
To upload the firmware file or a Switch configuration file to a
TFTP server.
Syntax upload {firmware_toTFTP {<ipaddr>| <ipv6addr>}
<path_filename (64)> | cfg_toTFTP {<ipaddr>| <ipv6addr>}
<path_filename (64)>} config_id<integer (1-2)>}
Description The upload command uploads the Switch’s current settings to a
TFTP server.
Parameters firmware_toTFTP −
Upload the firmware on the Switch from a
TFTP server.
cfg_toTFTP − Specifies that the Switch’s current settings will be
uploaded to the TFTP server.
<ipaddr> − The IPv4 address of the TFTP server.
<ipv6addr> − The IPv6 address of the TFTP server.
<path_filename 64> −
The filename of the firmware or switch
configuration file on the TFTP server. You need to specify the
DOS path if the file is not at the root directory of the TFTP server.
config_id <integer 1-2> -
Specifies the configuration id to be
configured.
Restrictions None.
Example usage:
To upload a firmware file:
DGS-1210-08P> upload firmware_toTFTP 192.168.11.141
Image Upload Successfully.
DGS-1210-08P>