xStack
®
DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
154
Parameter Description
Enter the destination network address of the route want to be displayed.
IP Address
Enter the destination IP address of the route want to be displayed. The longest prefix
matched route will be displayed.
Tick the check box to display only RIP routes.
Tick the check box to display only OSPF routes.
Tick the check box to display only the routes that have been written into the chip.
Tick the check box to display only BGP routes.
Click the Find button to locate a specific entry based on the information entered.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
IPv6 Static/Default Route Settings
A static entry of an IPv6 address can be entered into the Switch’s routing table for IPv6 formatted addresses.
To view the following window, click L3 Features > IPv6 Static/Default Route Settings, as show below:
Figure 5-3 IPv6 Static/Default Route Settings window
The fields that can be configured are described below:
Parameter Description
IPv6 Address/Prefix
Enter the destination network for the route, or tick the Default check box to be
assigned to the default route.
check box and enter the IP tunnel name used.
The IP Interface where the static IPv6 route is created.
The corresponding IPv6 address for the next hop Gateway address in IPv6 format.
Metric (1-65535)
The metric of the IPv6 interface entered into the table representing the number of
routers between the Switch and the IPv6 address above. Metric values allowed are
Backup State
Each IPv6 address can only have one primary route, while another route should be
assigned to the backup state. When the primary route fails, the switch will try the
backup route. The field represents the Backup for the IPv6 configuration. This field
may be Primary or Backup.
Click the Apply button to accept the changes made.
Click the Delete All button to remove all the entries listed.
To Next Page
Loading...
