D-Link DGS-3620-52P - Route Map Settings

xStack
®
DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
255
Route Map Settings
This window is used to create a route map or add/delete sequences to a route map.
To view the following window, click L3 Features > IP Route Filter > Route Map Settings, as shown below:
Figure 5-14154 Route Map Settings window
The fields that can be configured are described below:
Parameter Description
Route Map Name
Enter the route map name.
Click the Find button to locate a specific entry based on the information entered.
Click the Add button to add a new entry based on the information entered.
Click the View All button to display all the existing entries.
Click the Delete All button to remove all the entries listed.
Click the
View Detail
Click the Delete button to remove the specific entry.
link to view more information regarding the specific entry.
Click the
View Detail link to see the following window.
Figure 5-1425 Route Map Settings - View Detail window
The fields that can be configured are described below:
Parameter Description
Sequence ID (1-
65535)
Enter the sequence number for the rule.
Direction
Use the drop-down menu to Permit or Deny the matched rule.
Click the Add button to add a new entry based on the information entered.
Click the <<Back button to return to the previous window.
Click the Delete All button to remove all the entries listed.
Click the Edit button under Match Clause or Set Clause to configure the clause.
Click the Delete button to remove the specific entry.
Click the Edit button under Match Clause to see the following window.