D-Link DGS-3620-52P - RADIUS Accounting Settings

xStack
®
DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
330
Figure 8-14 Authentication RADIUS Server Settings window
The fields that can be configured are described below:
Parameter Description
Index Choose the desired RADIUS server to configure: 1, 2 or 3 and select the IPv4
Address.
IPv4 Address
Set the RADIUS server IP address.
IPv6 Address
Set the RADIUS server IPv6 address.
Authentication Port
(1-65535)
Set the RADIUS authentication server(s) UDP port which is used to transmit
RADIUS data between the Switch and the RADIUS server.
Accounting Port (1-65535)
Set the RADIUS account server(s) UDP port which is used to transmit RADIUS
accounting statistics between the Switch and the RADIUS server.
Timeout (1-255)
Set the RADIUS server age-out, in seconds.
Retransmit (1-20)
Set the RADIUS server retransmit time, in times.
Key
Set the key the same as that of the RADIUS server.
Confirm Key
Confirm the key the same as that of the RADIUS server.
Click the Apply button to accept the changes made.
RADIUS Accounting Settings
Users can configure the state of the specified RADIUS accounting service.
To view this window, click Security > RADIUS > RADIUS Accounting Settings as shown below:
Figure 8-15 RADIUS Accounting Settings window