D-Link DGS-3620-52P - Time Zone Settings

xStack
®
DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
405
Figure 9-33 SNTP Settings window
The fields that can be configured are described below:
Parameter Description
SNTP State
Use this radio button to enable or disable SNTP.
Current Time
Displays the Current Time.
Time Source
Displays the time source for the system.
IPv4 SNTP Primary
Server
The IPv4 address of the primary server from which the SNTP information will be taken.
IPv4 SNTP
Secondary Server
The IPv4 address of the secondary server from which the SNTP information will be
taken.
IPv6 SNTP Primary
Server
The IPv6 address of the primary server from which the SNTP information will be taken.
IPv6 SNTP
Secondary Server
The IPv6 address of the secondary server from which the SNTP information will be
taken.
SNTP Poll Interval In
Seconds (30-99999)
The interval, in seconds, between requests for updated SNTP information.
Click the Apply button to accept the changes made.
Time Zone Settings
Users can configure time zones and Daylight Savings Time settings for SNTP.
To view this window, click Network Application > SNTP > Time Zone Settings as shown below: