D-Link DGS-3620-52P - Lldp-Med

xStack
®
DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
142
Figure 4-111 LLDP Remote Port Information – Show Normal window
Click the <<Back button to return to the previous page.
LLDP-MED
LLDP-MED System Settings
This window is used to configure the LLDP-MED log state and the fast start repeat count, and display the LLDP-
MED system information.
To view the following window, click L2 Features > LLDP> LLDP-MED > LLDP-MED System Settings, as show
below:
Figure 4-112 LLDP-MED System Settings window
The fields that can be configured are described below:
Parameter Description
LLDP-MED Log State
Click the radio buttons to enable or disable the log state of LLDP-MED events.
Fast Start Repeat Count
(1-10)
Enter a value between 1 and 10 for the fast start repeat count. When an LLDP-
MED Capabilities TLV is detected for an MSAP identifier not associated with an
existing LLDP remote system MIB, then the application layer shall start the fast
start mechanism and set the ‘medFastStart’ timer to ‘medFastStartRepeatCount’
times 1. The default value is 4.
Click the Apply button to accept the changes made for each individual section.
LLDP-MED Port Settings
This window is used to enable or disable transmitting LLDP-MED TLVs.
To view the following window, click L2 Features > LLDP> LLDP-MED > LLDP-MED Port Settings, as show below: