D-Link DGS-3620-52P - IP Standard Access List Settings

xStack
®
DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
254
IP Standard Access List Settings
This window is used to create an access list used to filter routes.
To view the following window, click L3 Features > IP Route Filter > IP Standard Access List Settings, as shown
below:
Figure 5-13952 IP Standard Access List Settings window
The fields that can be configured are described below:
Parameter Description
Access List Name
Enter the name of the access list.
Click the Find button to locate a specific entry based on the information entered.
Click the Add button to add a new entry based on the information entered.
Click the View All button to display all the existing entries.
Click the Delete All button to remove all the entries listed.
Click the
View Detail
Click the Delete button to remove the specific entry.
link to view more information regarding the specific entry.
Click the
View Detail link to see the following window.
Figure 5-14053 IP Standard Access List Settings - View Detail window
The fields that can be configured are described below:
Parameter Description
Direction
Use the drop-down menu to Permit or Deny the specified network.
Access Address
Enter the network address.
Access Mask
Enter the mask address of the network address.
Click the Add button to add a new entry based on the information entered.
Click the <<Back button to return to the previous window.
Click the Delete button to remove the specific entry.