EasyManua.ls Logo

D-Link DGS-3620-52P - BGP Clear Settings

D-Link DGS-3620-52P
505 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
xStack
®
DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
249
The fields that can be configured are described below:
Parameter Description
Peer Established
Trap State
Enable or disable the sending of the peer established trap. The default value is
Disabled.
Peer Idle Trap State
Enable or disable the sending of the peer idle trap. The default value is Disabled.
Click the Apply button to accept the changes made for each individual section.
BGP Clear Settings
This window is used to reset the Border Gateway Protocol (BGP) connections using hard or soft reconfigurations.
To view the following window, click L3 Features > BGP > BGP Clear Settings, as shown below:
Figure 5-13144 BGP Clear Settings window
The fields that can be configured are described below:
Parameter Description
Type Use the drop-down menu to select IP Address, AS, Peer Group, External, or All.
IP Address - Specify to reset the session with the specified neighbor.
AS - Specify to reset sessions with BGP peers in the specified Autonomous System.
Peer Group - Specify to reset a peer group.
External - Specify all eBGP sessions will be reset.
All - Specify that all current BGP sessions will be reset.
IP Address If IP Address is selected in the Type drop-down menu, enter an IP address.
AS Number (1-65535) If AS is selected in the Type drop-down menu, enter an Autonomous System number.
Peer Group Name If Peer Group is selected in the Type drop-down menu, enter a peer group name.
Mode Option Tick the desired mode option: Soft, In, Prefix Filter or Out.
SoftThis initiates a soft reset. It does not tear down the session.
InThis iInitiates inbound reconfiguration. If neither in nor out keywords are specified,
both inbound and outbound sessions are reset.
Prefix FilterThe local site configured prefix filter will be notified to the remote
neighbor when inbound soft reset is applied.
OutThis initiates outbound reconfiguration.
Click the Apply button to accept the changes made for each individual section.

Table of Contents

Other manuals for D-Link DGS-3620-52P

Related product manuals