D-Link DGS-3620-52P - Page 369

xStack
®
DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
359
Figure 8-44 Port Security Settings window
The fields that can be configured are described below:
Parameter Description
Port Security Trap/Log
Settings
Use the radio button to enable or disable Port Security Traps and Logs on the
Switch.
System Maximum
Address (1-3328)
Enter the system maximum address.
From Port / To Port
Use the drop-down menus to select a range of ports to configure.
Admin State
Use the drop-down menu to enable or disable Port Security (locked MAC address
table for the selected ports).
Lock Address Mode
This drop-down menu allows the option of how the MAC address table locking will be
implemented on the Switch, for the selected group of ports. The options are:
Permanent – The locked address will not age out, even if the Switch has been reset
or rebooted, unless the user removes it manually.
DeleteOnTimeout – The locked addresses will age out after the aging timer expires.
DeleteOnReset – The locked addresses will not age out until the Switch has been
reset or rebooted.
Max Learning Address
(0-3328)
Specify the maximum value of port security entries that can be learned on this port.
Click the Apply button to accept the changes made for each individual section.
Click the Edit button to re-configure the specific entry.
Click the View Detail button to display the information of the specific entry.
Click the View Detail button to see the following window.