xStack
®
DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
443
Figure 11-25 Ping Test window
The user may click the Infinite times radio button, in the Repeat Pinging for field, which will tell the ping program to
keep sending ICMP Echo packets to the specified IP address until the program is stopped. The user may opt to
choose a specific number of times to ping the Target IP Address by clicking its radio button and entering a number
between 1 and 255.
The fields that can be configured are described below:
Parameter Description
Click the radio button and enter an IP address to be pinged.
Click the radio button and enter the domain name of the host.
Repeat Pinging for
Enter the number of times desired to attempt to Ping either the IPv4 address or the
IPv6 address configured in this window. Users may enter a number of times between
For IPv6 only, enter a value between 1 and 6000. The default is 100.
Timeout Select a timeout period between 1 and 99 seconds for this Ping message to reach its
destination. If the packet fails to find the IP address in this specified time, the Ping
Source IP
the source IP/IPv6 address of the ping packets. If specifies source IP/IPv6 address,
the IP/IPv6 address will be used as the packets’ source IP address that ping send to
Click the Start button to initiate the Ping Test.
After clicking the Start button, the following page will appear:
To Next Page
Loading...
