D-Link DGS-3620-52P - Page 471

xStack
®
DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
461
Log Message: The IPv6 address < ipv6address > on interface <ipif-
name> was deleted.
Parameters description:
ipv6address: ipv6 address obtained from a DHCPv6 server.
ipif-name: Name of the DHCPv6 client interface.
DHCPv6 Relay
Event description: DHCPv6 relay on a specify interface’s administrator
state changed
Log Message: DHCPv6 relay on interface <ipif-name> changed state to
[enabled | disabled]
Parameters description:
<ipif-name>:
Name of the DHCPv6 relay agent interface.
Informational
DHCPv6 Server
Event description: The address of the DHCPv6 Server pool is used up
Log Message: The address of the DHCPv6 Server pool <pool-name> is
used up.
Parameters description:
<pool-name>: Name of the DHCPv6 Server pool.
Informational
Event description: The number of allocated ipv6 addresses is equal to
4096
Log Message: The number of allocated ipv6 addresses of the DHCPv6
Server pool is equal to 4096.
Parameters description:
Informational
IP Directed-
Broadcast
Event description: IP Directed-broadcast rate exceed 50 packets per
second on a certain subnet.
Log Message:
IP Directed Broadcast packet rate is high on subnet.
[(IP: %s)]
Parameters description:
IP: the Broadcast IP destination address.
Informational
Event description: IP Directed-broadcast rate exceed 100 packets per
second
Log Message: IP Directed Broadcast rate is high.
Parameters description:
Informational
RCP
Event description: Firmware upgraded successfully.
Log Message: [RCP(1):] [Unit <unitID>,] Firmware upgraded by
<session> successfully. (Username: <username>, IP: <ipaddr>, MAC:
<macaddr>)
Parameters description:
unitID: Represent the id of the device in the stacking system.
session: The user’s session.
username: Represent current login user.
ipaddr: Represent client IP address.
macaddr : Represent client MAC address.
Informational
Event description: Firmware upgrade unsuccessfully.
Log Message: [RCP(2):] [Unit <unitID>,] Firmware upgrade by <session>
unsuccessfully. (Username: <username>, IP: <ipaddr>, MAC: <macaddr>)
Parameters description:
unitID: Represent the id of the device in the stacking system.
session: The user’s session.
username: Represent current login user.
ipaddr: Represent client IP address.
macaddr :
Represent client MAC address.
warning
Event description: Firmware uploaded successfully.
Log Message: [RCP(3):]Firmware uploaded by <session> successfully.
(Username: <username>, IP: <ipaddr>, MAC: <macaddr>)
informational