D-Link DIR-895L

43D-Link DIR-895L User Manual
Section 4 - Conguration - Router Mode
PPPoE
Address Mode:
Dynamic IP
⌵
Service Name:
Primary DNS Server:
Secondary DNS Server:
MTU: Auto
⌵
Mac Address Clone: << MAC Address
⌵
VLAN:
Disabled
COPYRIGHT © 2016 D-Link
DIR-895L HW:A1 FW:1.12
Settings >> Internet
SettingsHome Features Management
IPv6
Save
Internet
Use this section to congure your Internet Connection type. There are several connection types to choose
from Static IP, DHCP, PPPoE, PPTP, L2TP and DS-Lite. If you are unsure of your connection method, please
contact your Internet service provider. Note: If using the PPPoE option, you will need to remove or disable
any PPPoE client software on your computers.
My Internet Connection is: PPPoE
⌵
Advanced Settings ...
Username:
Password:
Reconnect Mode: On demand
⌵
Maximum Idle Time: 5 minutes
COPYRIGHT © 2016 D-Link
Select PPPoE if your ISP provides and requires you to enter a PPPoE username and password
in order to connect to the Internet.
Username: Enter the username provided by your ISP.
Password: Enter the password provided by your ISP.
Reconnect Mode: Select either Always-on, On-Demand, or Manual.
Maximum Idle
Time:
Enter a maximum idle time during which the Internet connection
is maintained during inactivity. To disable this feature, enable Auto-
reconnect.
Advanced Settings
Address Mode: Select Static IP if your ISP assigned you the IP address, subnet mask,
gateway, and DNS server addresses. In most cases, select Dynamic IP.
Dynamic IP
Service Name: Enter the ISP service name (optional).
Primary DNS
Server:
Enter the primary DNS server IP address assigned by your ISP.
Secondary DNS
Server:
Enter the secondary DNS server IP address assigned by your ISP.
MTU: Maximum Transmission Unit - you may need to change the MTU for
optimal performance with your ISP. The recommended setting is Auto.
My Internet
Connection Is:
PPPoE