D-Link DVA-5582

23D-Link DVA-5582 User Manual
Section 3 - Conguration
IPv4 Interface (IP over ATM)
Select Yes to enable NAT (Network Address Translation) or No
to disable. NAT is a form of firewall and enabling it is strongly
recommended. The default is Yes.
Enter your static IP address for IP over ATM. This information should
be provided by your ISP.
Enter the subnet mask for you IPv4 address here. This information
should be provided by your ISP.
Select Yes to set this connection as the default source for your
Internet connection. Selecting No will require manual connection
in advanced settings. The default setting is Yes.
Select No to get DNS information automatically from DHCP. Select
Yes to setup DNS manually, and you will be prompted for a preferred
and alternate server.
Enter the IP address of your preferred DNS Server. This eld only
appears if Setup Static DNS Servers is set to Yes.
Enter the IP address of your alternate DNS server. This eld only
appears if Setup Static DNS Servers is set to Yes.
Enable NAT:
IPv4 Address
Subnet Mask:
Setup as Default
Route:
Setup Static DNS
Servers:
Preferred DNS
Server:
Alternate DNS
Server
DNS Conguration
Click Cancel to return to the homescreen, or Back to return to the previous screen.
Click Next to congure IPv6 Interface Settings on page 25.