D-Link M30 - Page 67

63D-Link M30 AX3000 Dual-Band Wi-Fi 6 Router User Manual
Section 3 - Conguration
DHCP IP Address
Range:
Enter the starting and ending IP addresses for the DHCP server’s IP
assignment.
Note: If you have reserved static IP addresses for client devices, make sure
the IP addresses are outside of this range or you might have an IP conict.
DHCP Lease
Time:
Enter the length of time for the IP address lease in minutes. The default
is 10,800 minutes.
Always
Broadcast:
Enable this feature to broadcast your network's DHCP server to LAN/
WLAN clients.
WAN Port Speed: You may set the port speed of the Internet port to 10 Mbps, 100 Mbps,
1000 Mbps, or Auto (recommended).
UPnP: Enable or disable Universal Plug and Play (UPnP). UPnP provides
compatibility with networking equipment, software, and peripherals.
This is enabled by default.
IPv4 Multicast
Streams:
Enable to allow IPv4 multicast trac to pass through the router from
the Internet. This is enabled by default.
IPv6 Multicast
Streams:
Enable to allow IPv6 multicast trac to pass through the router from
the Internet. This is enabled by default.
Network
DHCP Server
Advanced Settings...