D-Link M30 - Static Routing Configuration

78D-Link M30 AX3000 Dual-Band Wi-Fi 6 Router User Manual
Section 3 - Conguration
Static Routes - IPv4
The Static Routes section allows you to dene custom routes to control how
trac moves around your network.
In the Features tab on the left side of the page, click Static Routes. To
congure IPv6 routes, click IPv6 and refer to Static Routes - IPv6 on page
79. To return to the main IPv4 static routes page, click IPv4.
To remove a rule, click on the trash can icon in the Delete column. To edit a
rule, click on the pencil icon in the Edit column. To create a new route, click the
Add Route button. Click Save when you are done. If you edit or create a route,
the following options will appear:
Name: Enter a name for the route.
Destination
Network:
Enter the destination IP address of this route.
Mask: Enter the subnet mask of the route.
Gateway: Enter your next hop gateway to be taken if this route is in use.
Metric: The route metric is a value from 1 to 16 that indicates the cost of
using this route. A value of 1 represents the lowest cost and 16 the
highest cost.
Interface: Select an interface that the IP packet must use to transit out of the
router when this route is in use.
Click Apply when you are done.