D-Link MYDLINK DNR-322L User Manual

53D-Link DNR-322L User Manual
Section 3 - Conguration
Shows the camera connection status. The user can click
Connect or Disconnect to change the connection status.
Shows the recording schedule and current recording status of
the cameras. Please note that if the camera is disconnected,
the recording may continue but will produce blank video.
Displays the frame rate of the camera.
Displays the transmission bit rate of the camera.
Note: If the Frame Rate or Bit Rate is too low, please check the
your network conguration between cameras and NVR. If the
bit rate is too high, it will cause the Live Video display slow or
lag, please modify the quality or bitrate setting in the camera
webGUIaccordingly.
Shows the hard drive space and estimated remaining recording
time status.
Note: The recording time information is estimated by current
bit rate. This may change each time a user refreshes this page.
Status
Connection
Status:
Recording
Status:
Frame Rate:
Bit Rate:
Disk Status:
This page displays the connection and recording status of your cameras.
Camera Status

D-Link MYDLINK DNR-322L Specifications

Power

power adapter	DC 12V/4 A
max power consumption	25.20 W
standby state max power consumption	0.23 W

Operating Environment

operating temperature	0˚ to 55˚ C (32˚ to 131˚ F)
storage temperature	Operating: 5% to 90% (non-condensing)

Memory

flash rom	128 MB
ram	256 MB DDR II

Weight and Dimensions

dimension	4.53 x 5.76 x 7.03 inches (115 x 146.4 x 178.5 mm)
weight	0.875 kg (1.93 lbs)