D-Link Wireless AC1200 User Manual

35D-Link DIR-850L User Manual
Section 3 - Conguration
L2TP
Enter the L2TP Server IP Address provided by your ISP.
Enter the Username provided by your ISP.
Enter the Password provided by your ISP.
Select either Always on, On demand, or Manual.
Enter a maximum idle time during which the Internet connection
is maintained during inactivity. To disable this feature, enable
Auto-reconnect.
Select Static IP if your ISP assigned you the IP address, subnet
mask, gateway, and DNS server addresses. In most cases, select
Dynamic IP.
Enter the L2TP IP Address provided by your ISP (for Static IP only).
Enter the L2TP Subnet Mask provided by your ISP (for Static IP
only).
Enter the L2TP Gateway IP Address provided by your ISP (for
Static IP only).
Enter the Primary DNS Server IP address assigned by your ISP.
Enter the Secondary DNS Server IP address assigned by your ISP.
L2TP Server IP
Address:
Username:
Password:
Reconnect Mode:
Maximum Idle
Time:
Address Mode:
L2TP IP Address:
L2TP Subnet
Mask:
L2TP Gateway IP
Address:
Primary DNS
Server:
Secondary DNS
Server:
Choose L2TP (Layer 2 Tunneling Protocol) if your Internet Service Provider (ISP) uses a L2TP connection. Your ISP can provide you with a username
and password.

D-Link Wireless AC1200 Specifications

General

Wireless Speed	1200 Mbps
LAN Ports	4 x 10/100/1000 Mbps
WAN Port	1 x 10/100/1000 Mbps
Wireless Standard	802.11ac
Frequency Bands	2.4 GHz, 5 GHz
Security	WPA, WPA2
Antenna Type	External