D-Link Wireless AC1200 User Manual

54D-Link DIR-850L User Manual
Section 3 - Conguration
Network
Enter the LAN IP Address of the router. The default IP address is
192.168.0.1.
If you change the IP address, once you click Save, you will need
to enter the new IP address in your browser to get back into the
conguration utility.
Enter the Subnet Mask of the router. The default subnet mask is
255.255.255.0.
The default address to access the router’s conguration utility is
http://dlinkrouter.local./ You may replace dlinkrouter with a name
of your choice by entering it into this eld.
Enter the Local Domain Name (optional).
If enabled, your computers will use the router for a DNS server.
Disable to transfer the DNS server information from your ISP to your
computers.
Enable or disable the DHCP server.
Enter the starting and ending IP addresses for the DHCP server’s IP
assignment.
LAN IP Address:
Subnet Mask:
Management
Link:
Local Domain
Name:
Enable DNS
Relay:
Status:
DHCP IP
Address Range:
This section allows you to change the local network settings of the router and to congure the DHCP (Dynamic Host
Control Protocol) settings. You can enable the use of the DIR-850L as a DNS server. From the Settings menu, click Network.
Click Advanced Settings... to expand the list and see all of the available options.

D-Link Wireless AC1200 Specifications

General

Wireless Speed	1200 Mbps
LAN Ports	4 x 10/100/1000 Mbps
WAN Port	1 x 10/100/1000 Mbps
Wireless Standard	802.11ac
Frequency Bands	2.4 GHz, 5 GHz
Security	WPA, WPA2
Antenna Type	External