51D-Link DIR-850L User Manual
Section 3 - Conguration
Wireless
Enable or disable the wireless frequency band.
Create a Wi-Fi Name for your wireless network using up to 32
characters.
Create a Password to use for wireless security. Wireless clients will
need to enter this password to successfully connect to the network.
Select None, WEP, or WPA/WPA2-Personal (recommended).
Select the preferred wireless networking standard for each band.
The available options will depend on the wireless frequency band,
as well as the currently selected security mode.
Select the desired channel. The default is Auto (recommended).
Select the desired wireless transmission power (High, Medium or
Low).
For the 2.4GHz band:
Select Auto 20/40 MHz if you are using both 802.11n and non-
802.11n wireless devices, or select 20 MHz if you are not using any
802.11n wireless clients.
For the 5GHz band:
Select Auto 20/40/80 MHz if you are using 802.11ac, 802.11n, and
non-802.11n wireless devices, or select Auto 20/40 MHz if you are
using both 802.11n and non-802.11n wireless devices.
Status:
Wi-Fi Name
(SSID):
Password:
Security Mode:
802.11 Mode:
Wi-Fi Channel:
Transmission
Power:
Channel Width:
From the Settings menu, click Wireless to begin wireless conguration. You will see the Wi-Fi Name (SSID) and Password
for both the 2.4GHz and 5GHz bands. Click Advanced Settings... to expand the list and allow you to view all elds
corresponding with each frequency band.
The following options apply to both the 2.4GHz and the 5GHz wireless frequency bands:
To Next Page
Loading...
Need help?
General
