DAELIM VJF125 - Page 138

9-7
A.C GENERATOR / STARTER CLUTCH
Install the woodruff key into the crank shaft key
groove.
Install starter idle gear and shaft.
Install new gasket and dowel pins.
Install the rotor bolt temporarily.
After fixing the flywheel with holder, tighten the
fly wheel nut.
TORQUE : 5.5kgf-m
TOOLS : FLYWHEEL HOLDER
LOCKNUT WRENCH
Install the LH. crank shaft cover at this time be
careful not to catch the wires in between the cover
and case.
FLY WHEEL
FLY WHEEL
FLY WHEEL
FLY WHEEL
FLY WHEEL
FLY WHEEL
FLY WHEEL
FLY WHEEL
FLY WHEEL
FLY WHEEL
FLY WHEEL
FLY WHEEL
FLY WHEEL
FLY WHEEL
FLY WHEEL
FLY WHEEL
FLY WHEEL
FLY WHEEL
FLY WHEEL
FLY WHEEL
FLY WHEEL
FLY WHEEL
IDLE GEAR
IDLE GEAR
IDLE GEAR
IDLE GEAR
IDLE GEAR
IDLE GEAR
IDLE GEAR
IDLE GEAR
IDLE GEAR
IDLE GEAR
IDLE GEAR
IDLE GEAR
IDLE GEAR
IDLE GEAR
IDLE GEAR
IDLE GEAR
IDLE GEAR
IDLE GEAR
IDLE GEAR
IDLE GEAR
IDLE GEAR
IDLE GEAR
ACG. CHANGE SWITCH WIRE
ACG. CHANGE SWITCH WIRE
ACG. CHANGE SWITCH WIRE
ACG. CHANGE SWITCH WIRE
ACG. CHANGE SWITCH WIRE
ACG. CHANGE SWITCH WIRE
ACG. CHANGE SWITCH WIRE
ACG. CHANGE SWITCH WIRE
ACG. CHANGE SWITCH WIRE
ACG. CHANGE SWITCH WIRE
ACG. CHANGE SWITCH WIRE
ACG. CHANGE SWITCH WIRE
ACG. CHANGE SWITCH WIRE
ACG. CHANGE SWITCH WIRE
ACG. CHANGE SWITCH WIRE
ACG. CHANGE SWITCH WIRE
ACG. CHANGE SWITCH WIRE
ACG. CHANGE SWITCH WIRE
ACG. CHANGE SWITCH WIRE
ACG. CHANGE SWITCH WIRE
ACG. CHANGE SWITCH WIRE
ACG. CHANGE SWITCH WIRE