1
EXTERNAL CAB COMPONENTS
Removal and installation LF45/55 series
4-12
4.12 REMOVAL AND INSTALLATION, WINDSCREEN
Removing the windscreen
1. Remove the grille.
2. Take the cover panel out of the window
frame.
3. Remove the windscreen wiper arms.
4. Remove the plastic cover strips on the
inside of the front-screen pillars (A-pillar).
5. Protect the curved areas on the outside of
the windscreen frame with linen tape. Also
use tape to protect the plastic parts on the
inside and the defroster openings of the
heating and ventilation system.
Note:
Take care not to damage the paint.
6. Put the wire (special tool,
DAF no. 1329415) at approximately the
middle of the upper and lower side of the
glass using pliers or a special pass-through
tool (special tool, DAF no. 1240458)
through the sealant.
Note:
Remove the wire pass-through tool before
fitting the wire ends to the handles of the
cutting wire set.
7. The length of the cutting wire should be
1.5 x the height of the windscreen.
8. Secure the handles that are part of the set,
special tool (DAF no. 0499817) to the
cutting wire.
K1 00 715
4
ǹ 0210
https://www.truck-manuals.net/
To Next Page
Loading...
Need help?
General
