1
LF45/55 series Removal and installation
EXTERNAL CAB COMPONENTS
4-17
4.13 REMOVAL AND INSTALLATION, REAR WINDOW GLASS
Removing the rear window glass
1. Remove the cover panel attachment bolts.
Remove the cover panels.
2. Attach a suction pad (DAF no. 0484800).
3. Put the wire (special tool,
DAF no. 1329415) at approximately the
middle of the upper and lower side of the
glass using pliers or a special pass-through
tool (special tool, DAF no. 1240458)
through the sealant.
Note:
Remove the wire pass-through tool before
fitting the wire ends to the handles of the
cutting wire set.
K1 01 131
4. The length of the cutting wire should be
1.5 x the height of the window.
5. Secure the handles that are part of the set,
special tool (DAF no. 0499817) to the
cutting wire.
6. Use tape strips to protect the glass from
falling out accidentally (after the sealant has
been cut through).
7. Start cutting in the middle.
Make sure the wire is kept moving and
tightly stretched all the time. If the wire gets
twisted, it will inevitably break.
8. Keep the cutting wire as close as possible
to the edge of the glass.
9. Make sure the wire ends are crossed before
the bottom corners are reached.
10. Take the glass out of the frame using a
suction pad, special tool
(DAF no. 0484800).
K1 01 059
4
ǹ 0210
https://www.truck-manuals.net/
To Next Page
Loading...
Need help?
General
