1
EXTERNAL CAB COMPONENTS
Removal and installation LF45/55 series
4-18
11. Remove any remaining sealant in the
window frame with a scraper, special tool
(DAF no. 1329417). Make sure the
remaining layer of sealant has a thickness
of at most 1 to 1.5 mm and that it is flat and
smooth.
12. Remove frayed pieces and granules of old
sealant and clean the frame thoroughly with
a cleaner.
Fitting the rear window glass
1. If necessary, smooth off spare sealant.
2. Apply the adhesive (1) as shown.
3. Fit the spraying nozzle to the cartridge and
apply the sealant to the window, spraying as
evenly as possible.
K1 01 178
9 mm
6 mm
1
4. Place the sealant gun with the opening
90_/60_ onto the windscreen and move it
evenly to build up a good layer.
5. Avoid air bubbles in the layer of sealant.
Note:
If a pneumatic glue gun is used for sealing
(special tool DAF no 1240444) then before
beginning adjust the pressure in the gun by
spraying several test strips.
6. Pay attention to the processing time, see
”Technical data”.
7. Fit the rear window glass and press it into
the frame. Secure the glass in several
places with strips of tape around 20 cm
long. Open the door windows to prevent
pressure in the cab.
K1 00 722
4
ǹ 0210
https://www.truck-manuals.net/
To Next Page
Loading...
Need help?
General
