1
EXTERNAL CAB COMPONENTS
Removal and installation LF45/55 series
4-16
4. Use a sealant remover to remove the
excess sealant immediately from the
painted parts, see ”Technical data”.
5. Depending on the type of sealant used
(hardening time), fit straps. See “Technical
data”. Protect the paint by fitting linen tape
in the places where the straps will touch the
paint.
6. If applicable, pull two strips round the
outside of the windscreen and the cab pillar.
Put strips of wood or Tempex underneath to
avoid damage.
7. Let the sealant harden. See “Technical
data”.
8. Remove from the cab body all the tape
used for protection and marking.
9. Clean the entire windscreen and the parts
of the cab body which have been fouled
during installation of the windscreen using a
glass cleaner.
10. Fit the A-pillar trimming panels in the cab.
11. Fit the cover panel to the window frame.
12. Fit the windscreen wipers and adjust them.
13. Fit the grille.
14. If the vehicle is fitted with an airbag, apply a
new airbag sticker to the windscreen.
K1 01 426
4
ǹ 0210
https://www.truck-manuals.net/
To Next Page
Loading...
Need help?
General
