1
LF45/55 series Removal and installation
EXTERNAL CAB COMPONENTS
4-15
Applying sealant
1. For hot processing, the adhesive should be
heated in an oven, special tool
(DAF no. 1329416) for 60 minutes at 80_C.
2. Apply the sealant to the rubber as indicated
in the diagram. There is no rubber on the
underside of the windscreen. Here, the seal
beads must be 11 mm from the edge of the
glass.
K1 01 215
15
8
3. Take note of the processing time when
applying the sealant. See “Technical data”.
4. Place the sealant gun with the opening
90_/60_ onto the windscreen and move it
evenly to build up a good layer.
5. Avoid air bubbles in the layer of sealant.
K1 00 722
Note:
If a pneumatic glue gun is used for sealing
(special tool DAF no 1240444) then before
beginning adjust the pressure in the gun by
spraying several test strips.
Fitting the glass
1. For safety, open the windows to avoid
undesirable pressure build-up on the
windscreen.
2. The glass should be taken from the
workbench by two persons and it should be
placed in the frame in one go. Use the tape
strips to determine the correct position.
3. Make sure that the rubber windscreen trim
on the bottom seats properly into the frame.
4
ǹ 0210
https://www.truck-manuals.net/
To Next Page
Loading...
Need help?
General
