1
EXTERNAL CAB COMPONENTS
Removal and installation LF45/55 series
4-14
Installing the windscreen
Be careful when using cleaner.
Contact with the cleaner will cause
skin irritation and swallowing will
cause burning.
Inhaling may cause breathing
problems.
1. Any damage to the paint should be repaired
well before the windscreen glass is placed.
Use the right type of paint.
2. Make sure that the guide rail is smooth and
flat (no major irregularities).
3. Check the windscreen for damage.
4. Attach two double suction pads, special tool
(DAF no. 0484800) to the outside of the
glass.
5. Put the windscreen with the suction pads on
a completely clean workbench.
6. Fit the rubber trimming to the glass and
secure it with tape on the outside of the
glass.
7. Place the glass in the frame without using
sealant, starting at the bottom and ensuring
that it fits exactly in the frame. If necessary,
fill up the rubber spacer blocks by means of
which the glass rests on the support blocks.
8. Mark the correct position of the glass in the
frame with strips of tape.
Cut through the tape in the frame.
9. Remove the glass from the frame and place
the glass on the workbench.
10. Clean the glass where the layer of sealant
is to be applied. See “Technical data”.
11. Clean the sealant within the frame.
K1 01 474
4
ǹ 0210
https://www.truck-manuals.net/
To Next Page
Loading...
Need help?
General
